Super G Carburetor Kit for 1957-'78 HD<sup>®</sup> Ironhead Sportster<sup>®</sup> Models (not equipped with vertical magnetos)

Super G Carburetor Kit for 1957-'78 HD® Ironhead Sportster® Models (not equipped with vertical magnetos)

Item #: 11-0424
0.0 out of 5
0 reviews | Write a Review
$599.95
PowerTerms

The complete S&S Super G carburetor kit contains everything you need for a complete installation on 1957-'78 HD® Sportster® models with standard tanks. This kit includes a manifold for engines with stock length cylinders. 2-1/16 Inch bore.

Does not fit engines equipped with vertical magneto.

 

 

Customer Reviews

There are no reviews for this product yet. Be the first!

Average Customer Rating

0.0 out of 5
 

0% of customers would recommend this product (0 out of 0)

Ratings Breakdown

  • 0% Rated this
    5
  • 0% Rated this
    4
  • 0% Rated this
    3
  • 0% Rated this
    2
  • 0% Rated this
    1

Write a Review

Write a Review

Would you recommend this product?
Showing 0 - 0 of 0 Reviews
Stock motorcycles 1980 or earlier must be updated to a two cable pull open/pull closed throttle control system. A single cable pull open system cannot pull the throttle closed in case the throttle should accidentally stick in the open position. S&S offers high quality throttle cable kits in several lengths for this purpose. A press-on sleeve is also available to increase the diameter of the throttle grip area of 1972 and earlier handle bars to 1", allowing installation of modern throttle assemblies. See Section 7 for throttle cables and press-on sleeves. S&S "Shorty" carburetors will not fit HD® ironhead Sportster® models with vertical magnetos due to clearance problems between the magneto and the carburetor. Shovelhead engines with five gallon gas tanks and cylinders that are taller than stock require a special notched air cleaner cover to clear the gas tank. Since these taller engines also require a special length manifold, select a carb with a notched air cleaner cover without a manifold from the chart and refer to the manifolds starting on page 5-50 - 5-51 to select the correct length manifold. S&S does not recommend polishing or chrome plating Super E & G carburetors. Our repair department has seen many carbs with passages plugged with polishing compounds and some carbs that had been destroyed because the polishing or chrome plating had altered critical machined surfaces. Recommended for closed circuit use only. S&S Super E & G carbs shown are not approved for use on motor vehicles operated on California public highways, or in other states where similar pollution laws may apply. The user shall determine the suitability of the product for his or her use and shall assume all risk and liability in connection therewith.
Disclaimer

NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLE. NOT LEGAL FOR SALE OR USE ON ANY EPA POLLUTION CONTROLLED MOTOR VEHICLE.