Zoom In Zoom Out Reset Enlarge

    S&S 106" Stock Bore Stroker Kit For Balanced 2003-'06 Big Twins

    Item #: 320-0453
    0.0 out of 5
    0 reviews | Write a Review
    $1,324.95
    PowerTerms

    Stock bore stroker kits have always been an economical way to increase the displacement of your engine. Installation of this kit does not require any special machining, other than fitting the pistons. S&S stroker pistons, which are sold separately, are available in all standard oversizes. Stock 88" cylinders can be bored from 33⁄4" bore to 37⁄8" to accommodate the S&S pistons, or a pre-fit S&S cylinder and piston kit may be installed. Engines with factory 95" kits require piston fitting for the correct oversize only. Stock or S&S cylinder heads can be used. Fuel injected engines will require recalibration of the fuel injection system – the S&S VFI modules and closed loop sensor kits are highly recommended. Since stock cylinders are used the engine height remains stock. This kit is engines with internal balancers only.

    Customer Reviews

    There are no reviews for this product yet. Be the first!

    Average Customer Rating

    0.0 out of 5
     

    0% of customers would recommend this product (0 out of 0)

    Ratings Breakdown

    • 0% Rated this
      5
    • 0% Rated this
      4
    • 0% Rated this
      3
    • 0% Rated this
      2
    • 0% Rated this
      1

    Write a Review

    Write a Review

    Would you recommend this product?
    Showing 0 - 0 of 0 Reviews
    This kit requires special pistons which must be ordered separately The sprocket shaft of this flywheel assembly comes with the bearing race for stock 2003-up left main bearing pre-installed. The pinion shaft of this flywheel assembly is equipped with a balancer drive chain sprocket. For internally balanced engines. Not legal for sale or use on CA or EPA pollution controlled vehicles 1978 and later.