i'm working on adding a sidecar to my 48 chief. i didn't spring for an original. i picked up a "Hitch Hiker" sidecar. it was built in the 80's, i believe. cosmetically, i can dress it up to look appropriate for the lines of the chief. the hardest challenge i'm finding is converting from the funky little trailer wheel it came with, to a normal spoked wheel. the car has a 1" diameter spindle that is just long enuff for a trailer wheel hub(approx 6"). i'm looking for ideas as to what spoked wheel hub can bee made to fit. i had a plan to run Indian rollers and cages on it. i have a front wheel hub from a Honda 350 that would easily accept the Chief front wheel rollers. then i was reminded that this axle probly hasn't been hardened and the rollers will just eat it up. the Timken bearings that fit this axle have an O.D. of just about 2". so i need a hub that can be machined big enuff to allow that big a hole. any ideas?