My high speed needle is two turns out.
Best regards Tony
choppertony wrote:Thank you for the tips cotten. I did as you told me and even the surface and I dint tighten the bolts so hard. I have now mounted an insulator plate on the linkert and now when I start the bike it works much better on high and low speed. But sure it poofs when I am too fast with the gas but maybe you shouldnt ask so much from an old linkert that are about 70 years old :D
choppertony wrote:I was lookin trough my bruce palmer book and I noticed that the throttle disc in my linkert is wrong. The disk that I use now is from a M-74B and it has an angel of 9 degrees X and the disc that the M35 shall have has an angel of 12 degrees.Can that have any effect on the low speed?
Users browsing this forum: No registered users and 3 guests