Board index Flathead Power-Technical Questions, Answers, and Suggestions 45 Flatties '49 WR Motor on Ebay

'49 WR Motor on Ebay

Post Tue Sep 13, 2011 12:03 pm

Posts: 349
Location: Champaign-Urbana, IL
Numbers are a little funky, but ...

Post Tue Sep 13, 2011 12:13 pm

Posts: 391
That one's been for sale on there for at least the last six months. It keeps changing a little each time. Started out as bare cases for sale.

Post Tue Sep 13, 2011 3:23 pm

Posts: 159
I thought drilling rods would be counterproductive. Was this standard? I thought that engineering practice went out with the Arc!

Post Tue Sep 13, 2011 4:16 pm

Posts: 391
All original WR rods as well as early KR rods are factory drilled. It still reduced reciprocating mass and was considered good practice for a long time. I have had lots of stock WL rods that were drilled by home tuners over the years. Some very poorly! :shock:

Post Tue Sep 13, 2011 5:47 pm
Pa Site Admin

Posts: 5843
Location: Ohio USA

If the entrance and exit shoulders of each hole have a small radius on the corners, along with a nice finish, I would think the rods may even be strengthened as a result of the modification, as well as lightened.

Return to 45 Flatties