Board index Flathead Power-Technical Questions, Answers, and Suggestions General Whatever-Technical Mystery (to me) Part #4

Mystery (to me) Part #4

Pretty much anything not covered by the topics above. Short lived production bikes or vehicles, Electrical, Tires, Paint, Brakes, etc. Use this for tech questions, and "Shoot the Bull" for general conversation, no tech.
Post Sun Feb 13, 2011 8:47 am

Posts: 125
Location: Southeast AZ
This wheel is also an 18". No markings found on the rim. On the inside back of the drum the number 3 is stamped in two places. There is also a stamping that looks like the bottom third of a sqaured letter U ( l_l ). Drum ID is 6-3/8' by 1" deep. The large flange has a hole in between each pair of spoke holes. ... /hole3.jpg ... /hole2.jpg ... /hole1.jpg
Aries51 (AKA Graybeard)

"Get on your bad motor scooter and ride"-Sammy Hagar

Post Sun Feb 13, 2011 11:27 am

Posts: 391
Rim profile looks Indian. I'm not familiar with them but 249/149 perhaps?

Return to General Whatever-Technical