Board index Flathead Power-Technical Questions, Answers, and Suggestions General Whatever-Technical Identify This Shifter Lever and Shaft Assembly

Identify This Shifter Lever and Shaft Assembly

Pretty much anything not covered by the topics above. Short lived production bikes or vehicles, Electrical, Tires, Paint, Brakes, etc. Use this for tech questions, and "Shoot the Bull" for general conversation, no tech.
Pa Site Admin

Posts: 5843
Location: Ohio USA

I don't recall ever seeing a shifter lever shaft assembly with a hooked rod end on it before. I was told it was a 45 part but it don't look like the 45 ones I am used to seeing. Pa

Image

Image


Posts: 172
Location: San Diego, CA
'38-'40 45" ? :?:

Pa Site Admin

Posts: 5843
Location: Ohio USA

Thanks. I looked at drawings of those years but can't really say for sure. The drawing qualities are not good enough to actually verify it as one of those. I also looked at early 45 levers but they are offset even greater.


Return to General Whatever-Technical