Board index Flathead Power-Technical Questions, Answers, and Suggestions Pans 58-58 Tank emblem

58-58 Tank emblem

Moderators: Curt!, Pa

Post Tue Jul 29, 2008 12:18 am

Posts: 161
Location: Radolfzell, Germany

how are these emblems originally attached to the tanks. Mine are a bit wobbly and I would like to fix them


Post Tue Jul 29, 2008 11:25 am

Posts: 2687
Location: Los Angeles, CA
They had rivits that went thru speednuts on the backside.

Post Tue Jul 29, 2008 12:28 pm

Posts: 43
The rivets, clips, and gaskets are available from Old Dude in GA.

Post Wed Jul 30, 2008 8:13 pm

Posts: 976
Location: Markt Einersheim, Germany


I sent you a PM did you receive it??


Post Thu Jul 31, 2008 12:40 am

Posts: 161
Location: Radolfzell, Germany

no. Not sure my adress is updated

Send to


Post Sun Sep 14, 2008 2:34 am

Posts: 43
Location: Plymouth,Ma. USA
I have a 57 pan with the same problem.The plastic emblems are loose. I want to remove and reinsall emblems for paint.
Is there a special tool? I understand that it's a rivet but not sure how to work with them.

Post Mon Sep 15, 2008 2:00 pm

Posts: 43
Use a punch with a concave tip to try to tighten the rivet by tapping lightly.
To remove the emblem, use a center punch to to locate the center of the rivet. Find a drill bit slightly smaller than the rivet head and drill it out. Go easy, you don't want to drill into the emblem. Once the head is gone, use a drill bit slightly smaller than the rivet shank, and drill it out.
Have the new rivets and clips on hand to gauge how far into the rivet to drill.

Return to Pans