Board index Flathead Power- General Announcements and Various Subjects Motorcycle Trivia Whats it - HD part

Whats it - HD part

Test your knowledge or someone else's with trivia questions about your favorite subject. Let's be realistic with the questions so everyone has a chance at answering them.

Moderators: Curt!, Pa

Post Tue Dec 18, 2007 10:01 pm

Posts: 607
Location: Menomonie, Wisconsin, USA
Certified HD part assembly - what is it for? Jerry

http://www.tractorshed.com/gallery/identify/id13375.jpg

Post Wed Dec 19, 2007 6:01 am

Posts: 377
Location: madison wisconsin usa
left to right hand shift linkage?

john

Post Wed Dec 19, 2007 6:26 am

Posts: 3123
Location: Central Illinois, USA
I don't know either,... but I have a similar bracket assembly without the linkage.

...Cotten

Post Wed Dec 19, 2007 7:47 am

Posts: 607
Location: Menomonie, Wisconsin, USA
John HD is right. It is the right hand shift cross over bellcrank for Knucklehead only. Big twin SV had a thru shaft under the tanks like Servi-car. This piece mounts on top of the rear motor mount and the lever pivots off of a special rocker arm end nut.

Jerry

Post Wed Dec 19, 2007 8:46 pm

Posts: 377
Location: madison wisconsin usa
dumb luck and a total guess on my part! :D

john

Post Wed Dec 19, 2007 8:59 pm

Posts: 1646
looks like classic HD engineering..... I like the detail about the modified rocker nut!
Shoot, a man could have a good weekend in Dallas with all that stuff...

Post Thu Jun 26, 2008 10:49 am

Posts: 923
Location: South Provence of FRANCE

Image

find it by yourself in this pic ....
Last edited by milwaukee belle on Thu Jun 26, 2008 10:52 am, edited 1 time in total.

Post Thu Jun 26, 2008 10:51 am

Posts: 923
Location: South Provence of FRANCE

Image

Post Thu Jun 26, 2008 11:10 am

Posts: 2685
Location: Los Angeles, CA
I see that you got to see Dale's Canadian prototype TA. Too bad it has funny numbers. Looks to be unmolested number boss stamped with J C Whitney stamps.


Return to Motorcycle Trivia