FAQ  •  Register  •  Login

resleeving ULH cylinder

Moderators: Curt!, Pa

<<

VFDBill

Posts: 17

Joined: Sun Mar 12, 2006 10:51 am

Location: Bowdoin Maine

Post Wed Mar 15, 2006 5:10 pm

resleeving ULH cylinder

I have a badly damaged UL cylinder with a sleeve already in it. How best to remove this sleeve for repair?
<<

Jerry Wieland

Posts: 606

Joined: Mon Nov 01, 1999 1:01 am

Location: Menomonie, Wisconsin, USA

Post Wed Mar 15, 2006 5:31 pm

I have never done this on a motorcycle sleeve but in dry sleeve tractors it works great. We weld vertically up and down on the sleeve until it drops out. The weld shrinks the sleeve.

Jerry
<<

woody

Posts: 491

Joined: Mon Apr 15, 2002 12:01 am

Location: Wa, USA

Post Wed Mar 15, 2006 8:41 pm

The welding works, and you can also bore the sleeve out until it is very thin, and then it will just peel out.
<<

100incscoot

Posts: 2399

Joined: Wed Dec 31, 2003 1:01 am

Location: atascadero cal usa

Post Wed Mar 15, 2006 9:53 pm

i actually have always used the bore out till then idea
never thought of jerry's idea
i think if i was to try that i'd heat the cyl b4 welding it cause welds expand b4 they contract and under expansion it may want to crack the cyl
<<

bikerblinky

Posts: 55

Joined: Wed Feb 02, 2005 1:01 am

Location: Midlothian, Texas

Post Tue Mar 21, 2006 1:11 pm

The weld idea will probably work fine, I use a similer technique to remove valve seats. Running around the top of the seat with a tig torch untel the seat pops out. 8) I agree, pre-heating is probably a good idea, especially on that old iron.
<<

gin

Posts: 171

Joined: Fri Jan 16, 2004 1:01 am

Location: vero beach FL.USA

Post Tue Mar 21, 2006 5:00 pm

Another trick is you warm the cylinder then pack the sleeve with dry ice or use a Co2 fire extinguisher to cool the sleeve, it usually will drop right out.

Return to Big Twin Flatties

Who is online

Users browsing this forum: No registered users and 2 guests

Powered by phpBB © 2000, 2002, 2005, 2007, 2012 phpBB Group.