FAQ  •  Register  •  Login

Big Twin Flathead Frame.

Moderators: Curt!, Pa


40UL Joe

Posts: 11

Joined: Mon Jan 09, 2006 8:04 am

Location: Bergen County New Jersey

Post Wed Jan 11, 2006 7:43 pm

Big Twin Flathead Frame.

Anyone out there know who manufactures a big twin rigid frame for my 40UL ? Mine was raked years ago,by cutting and bending the frame tubes in between the gas tanks.Been arround bikes for a while but never seen that done before.Have one supposedly on order from V Twin(TEDD) for the last nine weeks and still nothing,with no happy ending in sight.Need to get this project off the ground ! Would appreciate any info. Thanks JoeE
Joe E


Posts: 801

Joined: Sun Jan 09, 2000 1:01 am

Location: Planet Earth

Post Wed Jan 11, 2006 9:24 pm

I have seen a number of frames raked that way over the years.

As far as the frame from Teds, unless things have changed that frame is made in Connecticut and if I remember right it is done by Corbin or one of Corbins other companies. There are probably other companies making one but the frame from Teds sure looked good. I have never used one so I am not sure about the fit up.



Posts: 67

Joined: Wed Dec 01, 1999 1:01 am

Location: Australia

Post Wed Jan 11, 2006 10:49 pm

Try these guys



Return to Big Twin Flatties

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB © 2000, 2002, 2005, 2007, 2012 phpBB Group.