FAQ  •  Register  •  Login

KR cams?

Moderators: Curt!, Pa

<<

JIm

Posts: 801

Joined: Sun Jan 09, 2000 1:01 am

Location: Planet Earth

Post Sun Aug 21, 2005 2:12 pm

KR cams?

Anybody know of any that are available? I know someone that's looking for them.

Jim
<<

fantomen

User avatar

Posts: 54

Joined: Sun Jun 20, 2004 12:01 am

Location: Eskilstuna, Sweden

Post Sun Aug 21, 2005 2:35 pm

So do I.
<<

100incscoot

Posts: 2399

Joined: Wed Dec 31, 2003 1:01 am

Location: atascadero cal usa

Post Sun Aug 21, 2005 3:19 pm

good luck searching
<<

37ULH

Posts: 688

Joined: Mon Nov 25, 2002 1:01 am

Location: somerset, oh usa

Post Sun Aug 21, 2005 9:25 pm

Any / all KR grinds are available through Leineweber Cams. The cost is $300.00 and your cores. (std 45 cams wil do) If he has to replace any shafts, it's a little more.
KR cams can also be done at the WR angle as he has done a set for me.
http://www.leinewebercams.com
<<

Eric @ B.O.S

Posts: 950

Joined: Tue Nov 28, 2000 1:01 am

Location: Paris ::: France

Post Mon Aug 22, 2005 2:27 am

I may have a spare set, but I will only consider them in a TRADE deal and only for something I am in need of. Right now I need the following stuff:

- Early WR rear head (no popup) or set of heads
- WR peek-a-boo camcover
Eric @ B.O.S
www.beautyofspeed.com
A state of the art power quest
<<

37ULH

Posts: 688

Joined: Mon Nov 25, 2002 1:01 am

Location: somerset, oh usa

Post Mon Aug 22, 2005 6:10 am

What shafts for what application?
<<

Eric @ B.O.S

Posts: 950

Joined: Tue Nov 28, 2000 1:01 am

Location: Paris ::: France

Post Mon Aug 22, 2005 1:07 pm

37 ULH, is your question for me? If so shafts probably for WR (would have to check) but that can be changed easy anyways. As far as grinds go I have one set of Es or one set of F intake with E exhaust, maybe more depening on what anyone has to offer for trade.
Eric
<<

37ULH

Posts: 688

Joined: Mon Nov 25, 2002 1:01 am

Location: somerset, oh usa

Post Mon Aug 22, 2005 2:45 pm

No Eric, the question was posed to the others.
The shafts needed for the application was my concern.
WL cams sets are not too hard to find for reworking to KR specs but what shafts are needed for the end use?

Return to K-Models

Who is online

Users browsing this forum: No registered users and 4 guests

Powered by phpBB © 2000, 2002, 2005, 2007, 2012 phpBB Group.