Board index Flathead Power-Technical Questions, Answers, and Suggestions General Whatever-Technical Coker tires?

Coker tires?

Pretty much anything not covered by the topics above. Short lived production bikes or vehicles, Electrical, Tires, Paint, Brakes, etc. Use this for tech questions, and "Shoot the Bull" for general conversation, no tech.

Moderators: Curt!, Pa

Post Thu Nov 28, 2002 11:37 pm

Posts: 950
Location: Paris ::: France

I've heard good & bad about Coker tires. I'm running Avon MKII on my knuck, but might like to try the Diamond Tread from Coker on my next project. Any experience with these? Thanks,

Eric :: Knk45
A state of the art power quest

Post Fri Nov 29, 2002 4:25 am

Posts: 118
Location: USA

i've tried'em. kinda squirrely and low mileage.

Post Fri Nov 29, 2002 3:11 pm

Posts: 119
Eric, I haven't tried the diamond treads, But when I first restored my 40 ULH, I had a set of the Coker full height 5.00 by 16" jobs, and had to take them off again because of lumps in the side walls. Got stuck with them too, our buddy Ted would not take them back. I don't know what size you need, but the Avon "Safety mileage MKII" comes in 16, 18 and 19 inch sizes, and is a great alternitive. They are a full height profile tire.

Post Sat Nov 30, 2002 11:08 pm

Posts: 184
Location: Naples, Florida
Moons right, the diamond beck cokers I've run have always worn with a wierd pattern and fairly quick, but good in mud. I've had much better luck with the coker classics ( like the old goodyear tread).

Post Sat Nov 30, 2002 11:33 pm

Posts: 184
Location: Naples, Florida
Also, if you buy direct from Coker they will stand behind their tires.

Return to General Whatever-Technical