FAQ  •  Register  •  Login

VTwin Frames

Moderators: Curt!, Pa

<<

JIm

Posts: 801

Joined: Sun Jan 09, 2000 1:01 am

Location: Planet Earth

Post Sat Oct 05, 2002 4:26 am

VTwin Frames

Are Teds replica frames made in Tiwan or Connecticut?
http://www.cgfactory.com/

Oops
Then click on frame repair



[This message has been edited by JIm (edited 05 October 2002).]
<<

Boogiemanz1

Posts: 896

Joined: Mon Mar 06, 2000 1:01 am

Location: Bixby,OK, USA

Post Sat Oct 05, 2002 6:01 am

I have now and had in the past a few Corbin Gentry rigid "Chopper" frames frome the late seventies, early eighties. They have been of good quality, I just think to straighten a frame it ought to be bolted to something....jb
<<

m/cgeezer1945

Posts: 376

Joined: Sat Jun 08, 2002 12:01 am

Location: Lebanon, CT USA

Post Sat Oct 12, 2002 7:59 pm

Have sold 3 of these frames and so far everthing has fit, maybe a little nudge on the lower tank mount on 47 knuck frame, have had to work harder on some actual H-D frames... Their Springers are (same 3 customers) looked (from 5 feet away) and fit right also...geezer
<<

HOOTER

Posts: 1319

Joined: Sun Feb 25, 2001 1:01 am

Location: State College, Pa.

Post Mon Oct 14, 2002 4:48 am

I had gotten a Paughco frame last year that Had the swingarm pivot out of axis. After I got them in axis so the pivot bolt would thread in , the swingarm wasn't in line with the backbone. Straighten the swingarm area so the rear wheel was centered with the backbone and the sprockets were in line. It was alot worse than most wrecked frames I've straightened.

HOOT

Return to General Whatever-Technical

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB © 2000, 2002, 2005, 2007, 2012 phpBB Group.