Board index Flathead Power-Technical Questions, Answers, and Suggestions Knuckles Aftermarket shift gate

Aftermarket shift gate

Post Wed Nov 20, 2002 5:50 pm

Posts: 184
Location: Naples, Florida
Just got done converting my 46 knuck from a straight 3 speed to a 4 speed tranny. I used a cool cast bronze shift gate that has high gear forward so it shifts like my later ( 47 and up )bikes. Just flip the arm in the lid and used four speed drum and gears. Anybody know who manufactured these gates? They are very heavy castings and bolt right on the catseye tanks. I'm sure they came out right after 47 so you could convert your old bike to the new shift pattern.

Post Wed Nov 20, 2002 7:52 pm

Posts: 607
Location: Menomonie, Wisconsin, USA
I do not know who made them but they are not uncommon to find. Gonna use one on my 90" knuckle. Jerry

Post Sat Nov 23, 2002 2:36 pm

Posts: 184
Location: Naples, Florida
Conan, is that your 1945 knuckle on your web site you're talking about? If so looks nice, shotguns would be cool, post new pictures for us when you get sheetmetal back.

Return to Knuckles