You may try Precision Welding, Larry Smith in Lancaster. He does some frame repair and is the only authorized weldshop for Honda repair in all of Ohio and then some, I think. He'll at least know what your referencing as he does alot of vintage stuff also. Whether he'll take on that repair, I don't know. He also does magic on fin repairs, a specialty, along with manufacturing several 100K parts for Honda each year. My last visit he was finishing up a repair to a chief head that had required his building of 18 fins and straightening most of the rest. When finished the repairs were undetectable. Obviously he stays busy. A great guy, very knowledgable with no BS.
You're welcome. I take it that he wants another section rather than a bare head? He welded my WR cam lobes and did a beautiful job. I sure you'll be happy with his work. If you're coming this way, you're welcome to stop.
A bare head would be better. His is a mess. That is all he wants replaced, that I know of, on his frame. I appreciate the offer to pop in. Pm or email me your contact number. I'll call a few days before we head that way. Pa
Larry's work is impecable but I don't know what all he will take on. One thing for certain is that there is no BS. If he is not the best man for what you're needing or not set up to do what you need, he'll be straight up about it. If it's frame repair there's another guy but I'd have to contact him to see if it's okay to give out his info publically. He builds flattrack frames and has repaired a very rare cylinder for me that was almost beyond hope. Check Larry and if it doesn't work out, I'll check on the other fellow. Good luck!