FAQ  •  Register  •  Login

mikuni main jet

Moderators: Curt!, Pa

<<

Flatrat Richard

Posts: 54

Joined: Tue Oct 05, 1999 12:01 am

Location: cumberland WI USA

Post Thu Oct 07, 1999 5:16 am

I would sugest that you check for in take leaks Get the motor up to operation temp them set your ldle down to where she will just barley stay running take a can of carb cleaner and spray around your manifold if leak is bag motor will stall if only slight you will get a real rank smell out of exuast.
<<

panic

Post Thu Oct 07, 1999 11:48 am

What are the other jets?
<<

filthy

Posts: 136

Joined: Thu Sep 30, 1999 12:01 am

Location: oxford, NC USA

Post Sun Oct 10, 1999 11:32 pm

'Nother trick: Do the same as previously stated, but spray it with either ether or The Miracle Juice - WD-40. If there is a leak, the mill will rev.

If this is not the problem, raise the needle.

And if that fails, get a smaller needle before going to another jet..

Hope this helps,

filthy
<<

panic

Post Mon Oct 11, 1999 3:02 am

Again - what pilot jet, slide cutaway, needle jet, needle, needle notch? All of these affect mixture, not just the main.

Return to 45 Flatties

Who is online

Users browsing this forum: Bing [Bot] and 1 guest

Powered by phpBB © 2000, 2002, 2005, 2007, 2012 phpBB Group.