New Flathead Engines?

I see new Knucklehead, Panhead and Shovelhead complete, ready to run engines being produced by S&S and others, is anyone out there producing complete, ready to run Flathead engines here in the USA?

Not that I know of.
There's no aftermarket source for the engine cases.
Almost all other parts are available though, from different sources, like Tedd's V-Twin, 45 parts depot, NOSPARTS etc
Karl.

from his website ,moldthread is saying that wr cases will be availiable in the future

Kiwi Indian is offering a repo Indian Chief engine in 80 and 84 Cubic inches. Every one seems to think that they are excellent.
Dusty

Kiwi Indian is offering a repo Indian Chief engine in 80 and 84 Cubic inches. Every one seems to think that they are excellent.
Dusty

I just saw that. The quality and finish looks out of this world!

http://www.kiwi-indian.com/gallery/engines_new/

I wonder how much $$?

Maybe S&S will make a 45 soon, after all they have most everything except the cases.

Hey motogunner.
Are you sure S&S have any parts for a 45 engine? AFAIK they're selling UL aluminum heads, and that's all they have to offer for the flathead motors. Please share any good news you have in this matter.
Karl.

Hey motogunner.
Are you sure S&S have any parts for a 45 engine? AFAIK they're selling UL aluminum heads, and that's all they have to offer for the flathead motors. Please share any good news you have in this matter.
Karl.

They have flywheel assemblies, flywheels, heads and cylinder base studs. Maybe i was a bit over enthusiastic...

Hey motogunner.
Are you sure S&S have any parts for a 45 engine? AFAIK they're selling UL aluminum heads, and that's all they have to offer for the flathead motors. Please share any good news you have in this matter.
Karl.

Good news from S&S:

http://www.youtube.com/watch?v=HHGE_teYsYg&NR=1

It seems they are planning to offer a complete flathead engine. The video shows cylinders, etc, for flatheads.

not wanting to .but anyway , ...... i didnt hear in the vid.. there would be a complete flathead 'harley' type engins for sale at enytime ever by s&s . .

please correct me if im wrong.

regards jib

not wanting to .but anyway , ...... i didnt hear in the vid.. there would be a complete flathead 'harley' type engins for sale at enytime ever by s&s . .

please correct me if im wrong.

regards jib

By the end of the video they mention S&S would have a complete UL motor besides the knuckle, pan and shovelhead they have now. They also mentioned the cylinders were scheduled to be released by December but no mention of these on the S&S website. I wonder how much interest is out there for new flathead engines as they produce so little power and the cost is so high.

corrected, i must have gone off just before the end.

I suspect that the H-D market is covered by the knuckle, pan and shovel motors and there is a small market for consumables for ULs plus the rebuilt 45 motors ( in various capacities ) from various sources, plus the Kiwi indians which do indeed look like a quite remarkable piece of kit