Board index ‹ Flathead Power-Technical Questions, Answers, and Suggestions ‹ General Whatever-Technical ‹
Pretty much anything not covered by the topics above. Short lived production bikes or vehicles, Electrical, Tires, Paint, Brakes, etc. Use this for tech questions, and "Shoot the Bull" for general conversation, no tech.
Moderators: Curt!, Pa
Fri Nov 12, 1999 5:03 pm
Location: Lyons, Colorado, US
I went to replace the points in my '68 FLH and found that the stock ones (for '48-'69 FL/FLH) do not fit. The hole (in the half that rides the cam) that goes over the post on the points plate is too small. The stock size hole seems to be about .188" and my post is about .200".
Do any of you guys know what bike (or car?) uses points that fit on a .200" post?
[This message has been edited by Denny (edited 12 November 1999).]
Return to General Whatever-Technical