Board index Flathead Power-Technical Questions, Answers, and Suggestions General Whatever-Technical S&S rod rollers / cage question

S&S rod rollers / cage question

Pretty much anything not covered by the topics above. Short lived production bikes or vehicles, Electrical, Tires, Paint, Brakes, etc. Use this for tech questions, and "Shoot the Bull" for general conversation, no tech.
Post Mon Aug 06, 2012 4:36 pm

Posts: 4
I'm assembling a lower end and I'm re-using a set of S&S heavy duty rods.

Apparently there is a little wear on the crankpin or the rod races or both, so measurements tell me that
I need + .0004 oversize rollers.

Now I'm looking to purchase the rollers, but every source I've looked at breaks it down as follows:
1. 1941 - 1972 with steel cages and 18 rollers
2. 1973 up with alloy cages and 17 rollers.

My S&S rods have steel cages that hold 16 rollers in each of the 3 rows.

Are these unique to S&S rods?
Where can I purchase them?
Are the rollers dimensionally equivalent to either of the commonly listed year groups?

Would it just be easier to purchase common H-D cages and load them with the easily
available rollers?

Thanks for any and all help.
Last edited by Saintly on Sat Nov 03, 2012 3:23 pm, edited 1 time in total.

Post Tue Aug 07, 2012 7:54 pm
Pa Site Admin

Posts: 5843
Location: Ohio USA

Email this address for answers to your questions. Regards, Pa

Post Wed Aug 22, 2012 12:38 pm

Posts: 112
what did you find out :?:

Post Sat Nov 03, 2012 3:25 pm

Posts: 4
X-WLCH wrote:
what did you find out :?:

I never did find out why my cages & rollers were different, I just purchased a new set of early cages and the early rollers to fill them.

Return to General Whatever-Technical