FAQ  •  Register  •  Login

Megaphones examined

Moderators: Curt!, Pa

<<

panic

Post Fri Sep 17, 2010 12:38 pm

Megaphones examined

..
Last edited by panic on Sun Nov 28, 2010 12:27 pm, edited 1 time in total.
<<

jib

Posts: 575

Joined: Sat Dec 10, 2005 3:36 pm

Location: devon,england

Post Sat Sep 18, 2010 4:40 am

Re: Megaphones examined

interesting read panic, thanks for posting the link

so looks like i need some 1.50 od pipe and some 18 gauge sheet to start rolling my cones out of.

45 with shaved heads [about 6:1] ,releived valves ,kh cams with angle groung roller followers, cleaned up ports and homemade two into one , mikuni 34 on blended lenghtened manifold,33 tooth engine sprocket 18 x400 distanzia avon tyre. is pulling 80mph in top but feels like it would go more, ie no throttle response at full throtttle, {faster as roll of] going to put a 260 main jet in on monday to replace the 270 inat the moment, also going to fit the 34 tooth motor sprocket.
Dude, check out that jibhead, he's crazy. Hasn't been sober for 40 years
<<

panic

Post Sat Sep 18, 2010 8:27 am

Re: Megaphones examined

..
Last edited by panic on Sun Nov 28, 2010 12:27 pm, edited 1 time in total.
<<

jib

Posts: 575

Joined: Sat Dec 10, 2005 3:36 pm

Location: devon,england

Post Sat Sep 18, 2010 11:27 am

Re: Megaphones examined

panic ,thank you for the pointers and for doing the math , will look into pipes / bends etc next week ,regards jib
Dude, check out that jibhead, he's crazy. Hasn't been sober for 40 years

Return to General Whatever-Technical

Who is online

Users browsing this forum: No registered users and 2 guests

cron
Powered by phpBB © 2000, 2002, 2005, 2007, 2012 phpBB Group.