FAQ  •  Register  •  Login

wiring bug

Moderators: Curt!, Pa

<<

BAVARIAN_KNUCKLE

Posts: 154

Joined: Tue Jul 30, 2002 12:01 am

Location: Radolfzell, Germany

Post Wed Jul 03, 2013 1:21 am

wiring bug

help needed,

the first time after 12 years my 46FL left me in the lurch and I had to pick it up with a trailer. Shortcut in the wiring circuit.
Now, I resoldered some connections around battery ground and positive wire from the batterie to the frame post. The bike was back on the road ... not fully though:

When I put the ignition switch to running position, both control lamps work. When I turn the switch to the light position, the entire light system doesnt work and the 2 control lights in the dash go out. When I return the switch to the first position, the control lamps still dont work .. however, after some seconds they go on!. Then I can start the bike. When I then turn the switch back to the light position, the bike continues to run fine but the 2 control lamps start to slightly dim (the light works).

The bike has a brand new battery and I have a fuse between the positive post of the battery and the terminal post at the frame (close to the seat post). Otherwise the generator converted to 2 brush.

Any help is highly appreciated
Thanks
Klaus
<<

Chris Haynes

Posts: 2616

Joined: Wed Jul 05, 2000 12:01 am

Location: Los Angeles, CA

Post Sat Jul 06, 2013 12:16 am

Re: wiring bug

Bad switch?

Return to General Whatever-Technical

Who is online

Users browsing this forum: No registered users and 1 guest

cron
Powered by phpBB © 2000, 2002, 2005, 2007, 2012 phpBB Group.