Board index ‹ Flathead Power-Technical Questions, Answers, and Suggestions ‹ General Whatever-Technical ‹
Pretty much anything not covered by the topics above. Short lived production bikes or vehicles, Electrical, Tires, Paint, Brakes, etc. Use this for tech questions, and "Shoot the Bull" for general conversation, no tech.
Moderators: Curt!, Pa
Fri Apr 09, 2010 7:05 pm
Location: Berlin, MD
I got some real nice repro parts to restore my 1948 Speedo. only problem is that it reads a real high speed, about 74 when I am doing under 40. I was using a Teds 47 Repro and that was always right on, Is there a way to calibrate these better or does taht magnet deal need to be replaced. Parts sat in my garage for 35 years.
Sat Apr 10, 2010 10:02 am
Location: Los Angeles, CA
Sounds like you have the wrong ratio combination of speedometer and drive gear. There are 1 to 1 and 2 to 1 ratios.
Return to General Whatever-Technical