Board index Flathead Power-Technical Questions, Answers, and Suggestions Indians Sport Scout stroker project

Sport Scout stroker project

Moderators: Curt!, Pa

Post Sat Feb 17, 2007 5:32 am

Posts: 124
Location: Glenmoore, Pa. USA

Panic is correct about rod bushings which are supplied with the pin. You will need to PM me at for prices. Stock XL cages are used as are the rollers. Depending on the fit of taper to wheels, there will be some shimming needed using Indian thrust shims.

Post Mon Oct 29, 2007 1:22 pm

Posts: 85

Was is the prevailing wisdom on replacing the cam follower shafts?

Do they go in back to front ? front to back?

Heat and press?

I really don't want to screw this up.


Post Mon Oct 29, 2007 5:47 pm

Posts: 124
Location: Glenmoore, Pa. USA

The cases need to be split and the shafts are pressed out from the inside. You need to have the surrounding area around shaft supported before pressing out.
You need to hone the rockers to find the size shaft you need.
Installation is the reverse.


Return to Indians