Board index Flathead Power-Technical Questions, Answers, and Suggestions Indians bent rear frame

bent rear frame

Moderators: Curt!, Pa

Post Sat Aug 05, 2006 5:27 pm

Posts: 13
need help. appears that the rear section on my 1940 chief plunger frame has been tweeked. does anyone have blueprints or any measurements that i may use to repair? thought i seen some on virtual indian. can't locate them now....thanks

Post Sat Aug 05, 2006 9:25 pm

Posts: 13
all i really need is the distance frome top grease zert to top grease zert....bottom to bottom. maybe centerline also....

Post Sun Aug 06, 2006 8:03 am

Posts: 39
Location: Paris, France

Big Mike 38 wrote:
all i really need is the distance frome top grease zert to top grease zert....bottom to bottom. maybe centerline also....


on the blue print I have it's written 12.250 from zirc center to zirc center

--
Fred

Post Mon Aug 07, 2006 7:48 am

Posts: 197
Location: Bucktown, PA
Zerk

zzz

Post Mon Aug 07, 2006 6:27 pm

Posts: 13
zert, zerc, zerk...its z thing with z hole, where you put z grease.. would like to know the centerline. any help would be deeply appreciated..

Post Wed Aug 09, 2006 1:35 am

Posts: 39
Location: Paris, France

Big Mike 38 wrote:
zert, zerc, zerk...its z thing with z hole, where you put z grease.. would like to know the centerline. any help would be deeply appreciated..


well, again :
on the blue print I have it's written 12.250 from Z center to Z center
:)


Return to Indians