Sun May 30, 2010 8:21 am
Scout stroker pistons?
..
Last edited by panic on Sun Nov 28, 2010 6:11 pm, edited 1 time in total.
Scout stroker pistons?
3 posts
• Page 1 of 1
Sun May 30, 2010 10:48 am
Re: Scout stroker pistons?
In regards to milling the crown down, I guess it would depend on how much material will be left in the piston top verses the cavity inside of the piston Panic. Pa
Sun May 30, 2010 7:09 pm
Re: Scout stroker pistons?
Panic!
Why not just email Rocky direct at rocky@ironwigwam.com and ask him?
He has probably produced variations that better suit your needs, if those do not.
....Cotten
PS: I'd add a pic of of Rocky's "Dreamcatcher" LSR machine, but the attachment tab only shows up when it wants to!
Why not just email Rocky direct at rocky@ironwigwam.com and ask him?
He has probably produced variations that better suit your needs, if those do not.
....Cotten
PS: I'd add a pic of of Rocky's "Dreamcatcher" LSR machine, but the attachment tab only shows up when it wants to!
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 1 guest