Board index Flathead Power-Technical Questions, Answers, and Suggestions Knuckles Linkert float bowl

Linkert float bowl

Moderators: Curt!, Pa

Post Tue May 02, 2000 3:45 am

Posts: 91
Location: Labadie, Mo.
I just went thru my Linkert, and have some gas seepage from the bowl nut. I used a new copper washer, with the split side to the bowl. There is some pitting around the bottom hole. Does anyone have a "fix" for sealing the bowl and nut?

Post Tue May 02, 2000 12:27 pm

Posts: 3010
Location: Central Illinois, USA
I merely grind the pits out on a disc sander to leave a flat sealing surface. If they are too deep, I fill them first with J-B weld. (I put the split of the crush washer out towards the nut, although it probably makes no difference.)

Return to Knuckles