Board index Flathead Power-Technical Questions, Answers, and Suggestions Knuckles Knucklesand white Knuckles,bloodyknuckles

Knucklesand white Knuckles,bloodyknuckles

Moderators: Curt!, Pa

Post Wed Feb 02, 2000 2:38 pm

Posts: 3011
Location: Central Illinois, USA
Getting a complete seal seems to be a lot of trouble for little protection, particularly when the intake cups are actually perforated to allow air in, so that the oil can be sucked out. Messy knuckles are usually a result of over-oiling: more being pumped in than can be sucked back out. For '41 and later heads that do not have 'adjustable' rocker shafts, I commonly drill a .060" hole in a rivet that can be slipped into the bottom fitting of the overhead oil line as a metering orifice. This has proved adequate to lube,yet cleans up motors even when equipped with modern high-volume pumps...Cotten

Return to Knuckles