Board index Flathead Power-Technical Questions, Answers, and Suggestions Knuckles dash

dash

Moderators: Curt!, Pa

Post Tue Jul 19, 2011 3:10 pm

Posts: 43
Location: Copenhagen
Does anyone know why the center bolt holding the dash cover (47 up) is hollow ? :D
member of KillerBobbers

Post Tue Jul 19, 2011 5:58 pm

Posts: 391
To allow use of the accessory Dash choke control. If you look into the center bolt it has a reverse spiral cut into it. A control coil casing threads into it. The dash choke wasn't too popular but the center stud remained hollow throughout its life.
Robbie
Image
Image

Post Wed Jul 20, 2011 7:39 am

Posts: 43
Location: Copenhagen
Thank you very much :-)
member of KillerBobbers


Return to Knuckles