Board index Flathead Power-Technical Questions, Answers, and Suggestions Knuckles Low numbered tall rib 41 knuck cases

Low numbered tall rib 41 knuck cases

Moderators: Curt!, Pa

Post Sun Jun 05, 2011 6:53 pm

Posts: 17
Location: Mount Airy,Md.USA
I was under the impression that most 41 knuck cases had the short ribs, and if any had the tall ribs at all, they would be much later in the production run, hence a higher VIN. These cases have a pretty low numbered case number, but have tall ribs. Didn't 41 cases also have the number pad with the two bumps on it? Is this a number job?


Post Mon Jun 06, 2011 7:29 am

Posts: 607
Location: Menomonie, Wisconsin, USA
That is a number job.


Post Wed Jun 08, 2011 9:14 pm

Posts: 1004
Location: Ojo Caliente,NM,USA
Did it say 43 before they worked it with a wet rag and a ballpeen hammer?

Return to Knuckles