I have tried everything to remove these wheels short of heating them up and I think that would be a bad idea(?).
Have been looking for the proper tool but can't seem to find one(45restorations, NOSParts, V-Twin, J&P,Jireh etc.)(45Resto actually thinks he can get one made in a week or two).
I've used all of my pullers to no avail and tried a stack of old clutch plates which lined up perfectly but no go.
Thinking of cutting a horse shoe shaped piece out of some plate stock to to put on the back side (inside) of hub to try and draw them off but am concerned about damaging the hubs.
Is this a common problem or is it that these wheels probably haven't been off since Reagan was in office...the first time.
I'm in the East Bay CA
Thanks in advance.