Board index Flathead Power-Technical Questions, Answers, and Suggestions K-Models KR



Post Mon Jan 22, 2007 11:35 am

Posts: 118
Location: cornwall, ontario,canada
Hi guys, just picked up a 57 KR. It is absolutely all there and in fantastic shape. I'm going to need to rebuild the bottom end!!! Can anyone point me in the right direction. I need a crank pin with rollers and cages. Races look good on the rods. I also need a sprocket shaft. Can anyone tell me if there were cam bearing plugs in the case behind the cams like the WR. Thanks guys

Post Mon Jan 22, 2007 12:20 pm

Posts: 202
Location: Middle England UK

If you go on ebay and do search for seller 1thumper63 send him a message and see if he has them.He has alot of NOS and is good to deal with.


Post Wed Jan 24, 2007 8:03 pm

Posts: 149
Location: calif
hi nice find. no plugs in cases. easten and jims did make pins and shafts. on rollers very hard to find as i know no one ever made them aftermarket. rollers r same as kr xlr xr 750. 5/16 rollers. u need to measure rods to see what size u need. i have been racing krs xlrs since 1965. still do in vintage class. have a friend who had shats and pins made. hope u the best


Post Wed Jan 24, 2007 8:55 pm

Posts: 99
Location: Littleton, CO USA
8) I've got 3 XR crank pins, end plugs, cages, and a large assortment of rollers of various sizes. All NOS. Also, have two sets of used KR rods without races. Would consider selling all.

Return to K-Models