FAQ  •  Register  •  Login

KR cams

Moderators: Curt!, Pa

<<

STROKER

Posts: 104

Joined: Fri Jan 06, 2006 5:35 pm

Location: VOLUNTEER STATE

Post Wed Jun 28, 2006 4:28 pm

KR cams

I;m in the process of building an engine for a customer;KH top end on WL cases. Does anyone make the cam journals (shafts) to convert a KR cam to WL bearing sizes? I could machine a set ,but if some makes them,it might be cheaper to just buy a set. TIA STROKER
<<

mike100m

Posts: 51

Joined: Fri Jul 23, 2004 12:01 am

Location: felton,Ca.USA

Post Wed Jun 28, 2006 6:12 pm

cam shafts

I believe Leinweber Cams has them. 760-364-4432
<<

xlr

Posts: 149

Joined: Thu Aug 05, 2004 12:01 am

Location: calif

Post Wed Jun 28, 2006 7:09 pm

u can use k or kh shafts. but clearance lite press fit between cam and shaft. or any 45 cams with replaceable shafts. also remember kr cams r ground at a angle. wl cases r straght. also kh cases bored at a angle. one fix { tom sifton did a few sets} grind lifter rollers at a angle. but kh cases at a angle so valves will be at angle and lifters r straght. with wl. or if u can find wr lifter blocks r at a angle.
<<

xlr

Posts: 149

Joined: Thu Aug 05, 2004 12:01 am

Location: calif

Post Wed Jun 28, 2006 7:30 pm

also EASTON AND 45 PARTS DEPOT does

Return to K-Models

Who is online

Users browsing this forum: Google [Bot] and 1 guest

Powered by phpBB © 2000, 2002, 2005, 2007, 2012 phpBB Group.