KR cams

I;m in the process of building an engine for a customer;KH top end on WL cases. Does anyone make the cam journals (shafts) to convert a KR cam to WL bearing sizes? I could machine a set ,but if some makes them,it might be cheaper to just buy a set. TIA STROKER

I believe Leinweber Cams has them. 760-364-4432

u can use k or kh shafts. but clearance lite press fit between cam and shaft. or any 45 cams with replaceable shafts. also remember kr cams r ground at a angle. wl cases r straght. also kh cases bored at a angle. one fix { tom sifton did a few sets} grind lifter rollers at a angle. but kh cases at a angle so valves will be at angle and lifters r straght. with wl. or if u can find wr lifter blocks r at a angle.

also EASTON AND 45 PARTS DEPOT does