Board index Flathead Power-Technical Questions, Answers, and Suggestions K-Models KR Cases - any new ones?

KR Cases - any new ones?

Moderators: Curt!, Pa

Post Wed May 03, 2006 11:04 pm

Posts: 13
Location: Tennessee
Does anybody make a new set of KR cases? I would like to build a pop-up piston version (twin carb) and wonder how many of the parts are being made new?

Post Thu May 04, 2006 10:18 am
xlr

Posts: 149
Location: calif
i do make some parts. no cases available. i have done many k kh cases make them kr cases

Post Thu May 04, 2006 2:22 pm

Posts: 13
Location: Tennessee
XLR - how hard is it to make the K or KH cases into KR versions? If it is not too involved, would you provide some details?

Thanks

Post Thu May 04, 2006 5:36 pm

Posts: 2687
Location: Los Angeles, CA
XLR,
What parts do you make?

Post Thu May 04, 2006 7:04 pm
xlr

Posts: 149
Location: calif
otto bore main bearing in cases for ball bearing. bore cam bearing holes for ball bearings. bore front of cases for mag. and adp. relocate idler hole. later krs also had ball bearing in trans. on sprocket side.

Post Thu May 04, 2006 7:05 pm
xlr

Posts: 149
Location: calif
valve spring covers. alum oil tanks. and lot small parts.


Return to K-Models