Board index Flathead Power-Technical Questions, Answers, and Suggestions K-Models KR cams?

KR cams?

Moderators: Curt!, Pa

Post Sun Aug 21, 2005 2:12 pm
JIm

Posts: 801
Location: Planet Earth
Anybody know of any that are available? I know someone that's looking for them.

Jim

Post Sun Aug 21, 2005 2:35 pm

Posts: 54
Location: Eskilstuna, Sweden
So do I.

Post Sun Aug 21, 2005 3:19 pm

Posts: 2399
Location: atascadero cal usa
good luck searching

Post Sun Aug 21, 2005 9:25 pm

Posts: 693
Location: somerset, oh usa
Any / all KR grinds are available through Leineweber Cams. The cost is $300.00 and your cores. (std 45 cams wil do) If he has to replace any shafts, it's a little more.
KR cams can also be done at the WR angle as he has done a set for me.
http://www.leinewebercams.com

Post Mon Aug 22, 2005 2:27 am

Posts: 950
Location: Paris ::: France

I may have a spare set, but I will only consider them in a TRADE deal and only for something I am in need of. Right now I need the following stuff:

- Early WR rear head (no popup) or set of heads
- WR peek-a-boo camcover
Eric @ B.O.S
www.beautyofspeed.com
A state of the art power quest

Post Mon Aug 22, 2005 6:10 am

Posts: 693
Location: somerset, oh usa
What shafts for what application?

Post Mon Aug 22, 2005 1:07 pm

Posts: 950
Location: Paris ::: France

37 ULH, is your question for me? If so shafts probably for WR (would have to check) but that can be changed easy anyways. As far as grinds go I have one set of Es or one set of F intake with E exhaust, maybe more depening on what anyone has to offer for trade.
Eric

Post Mon Aug 22, 2005 2:45 pm

Posts: 693
Location: somerset, oh usa
No Eric, the question was posed to the others.
The shafts needed for the application was my concern.
WL cams sets are not too hard to find for reworking to KR specs but what shafts are needed for the end use?


Return to K-Models

cron