K MODEL CYLINDERS ON WL CASES

I'm wanting to put a K-Model top-end on a 45" bottom-end, as my next project.

Are the K-Model intake manifolds very hard to find ?

Are there any available from aftermarket resources ?

Hi Da.

I just finished the wax molds to investment cast the manifolds in silicon bronze this week.
They will be available in 3 configurations.
Standard 4 bolt 1-1/2" Linkert
38 mm Mikuni
40 mm Mikuni
They will be ready in about a month.
I have not even sent the molds to the investment caster yet.

Also working on manifold for the Indian Scout to take standard
Indian 3 bolt, 4 bolt 1-1/2" Harley or 38 mm Mikuni.

Bruce Argetsinger
AHRMA Dirt Track # 67J
http://www.enfieldracing.com

Thanks, Bruce !

link to my project.

http://www.hydra-glide.com/phpBB3/viewt ... =55&t=7618

glad to spot this thread, this is a project i am wanting to build!

George
i don't agree at all the way you have locked your rear brake plate .
with this mount : you run head first to the wall .

find something else and STRONGER , mechanically liveable .

fran 6 , think if you look at page 3 of the build you will see a much safer method of holding the caliper . regards jib