Board index Flathead Power-Technical Questions, Answers, and Suggestions Pans Gasline Fitting Sizes

Gasline Fitting Sizes

Moderators: Curt!, Pa

Post Wed Aug 09, 2006 8:06 pm
JIm

Posts: 801
Location: Planet Earth
Anybody know what the thread is on a later 50's (58 59) Panhead shutoff valve and filter is? Size and pitch. Also if they used a compression fitting (brass ferule or rubber) or something else to make the seal.

Thanks
J

Post Thu Aug 10, 2006 12:20 am

Posts: 630
Location: belgium
They used a rubber seal and the thread is "1/2 24
Stéph

Post Thu Aug 10, 2006 6:50 am
JIm

Posts: 801
Location: Planet Earth
1/2" sounds a tad large. Are you sure it's not 5/16", 3/8" or 7/16"?

Jim

Post Thu Aug 10, 2006 10:51 pm

Posts: 630
Location: belgium
Yes

Post Fri Aug 11, 2006 7:34 am
JIm

Posts: 801
Location: Planet Earth
Steph,

Are you talking about the thread in the tank? I am looking for the thread on the shutoff and the filter for the gas line.

J

Post Sat Aug 12, 2006 12:49 am

Posts: 630
Location: belgium
Yes I understood your question and yes the thread on the fuelfilter and shutoff is 0,493" outside...iff I'm not 99% sure I keep my mouth closed and here it's 100%.
:evil: Stéph


Return to Pans

cron