Board index Flathead Power-Technical Questions, Answers, and Suggestions Pans FL Inlet Nipple Dimensions Please

FL Inlet Nipple Dimensions Please

Moderators: Curt!, Pa

Post Thu Oct 07, 2010 4:22 pm

Posts: 84
Would anyone have an FL inlet nipple handy that could provide a couple dimensions - the nipple ID and the OD at the threads. If you would have the same dimensions for a UL nipple I'd also like to know that. Thank you.

Post Fri Oct 08, 2010 2:45 pm

Posts: 150
Location: Carver, MN

These measurements are from a Colony part for an FL, but may suffice. I.D. is 1.555" The O.D. of the threads (of the end that goes into the head) is 1.743". Sorry, but I don't have a UL nipple to measure.

Return to Pans