Board index Flathead Power-Technical Questions, Answers, and Suggestions Pans Solid state regulator question

Solid state regulator question

Moderators: Curt!, Pa

Post Sat Oct 25, 2008 7:55 pm

Posts: 2677
Location: Los Angeles, CA
I just picked up a 1950 Panhead that has a solid state regulator on it. All the wiring from the regulator to the dash is missing. Wires are dangiling here and there. The regulator is still connected to the generator, although I don't know if this is correct or not. Does anybody recgonize this regulator? Which wires go from it to where on the ignition switch? I have never messed with one of these before. :oops:
Thanks in advance.

Post Sat Oct 25, 2008 9:03 pm

Posts: 377
Location: madison wisconsin usa

not knowing the manufacture i would say in general it would be:



Post Wed Oct 29, 2008 6:53 pm

Posts: 646
Location: Detroit
If you look at the back of the unit you might find a manufacturer, etc., and then do a google for the spec sheet or instructions.
New Knuckleheads? Thank, you, Jesus!!

Return to Pans