Board index Flathead Power-Technical Questions, Answers, and Suggestions Pans Muffler Hangers

Muffler Hangers

Post Thu Nov 01, 2012 6:16 pm

Posts: 767
Location: Pa. , USA
Installing dual exhaust on my 65 Pan, according to the parts book there are 2 part numbers for the hangers, one right one left and both use a spacer ? Found some in my stash , when mounted they either bend inward or out ward depending how you mount them, not sure if they're correct or the correct way they mount, to make things more intresting I found one that when mounted is straight but bends up or down ,, any ideas ? thanks, Tim
Vintage roadracing, Class C, AHRMA # 335

Post Fri Nov 02, 2012 11:20 pm

Posts: 976
Location: Markt Einersheim, Germany

I was asking that question too for my mishmash 58FL project that I am collecting parts for and sending to the US.

Answer I got:

When looking forward from the rear wheel, the muffler supports:

Should point, Down and inward.


Post Sat Nov 03, 2012 9:07 am

Posts: 767
Location: Pa. , USA
Got that George, turning in while mounting on the outside of the frame, appears the pre 65 called for spacers , still baffled with the 2 part numbers , thanks for the reply, Tim
Vintage roadracing, Class C, AHRMA # 335

Return to Pans