Board index Flathead Power-Technical Questions, Answers, and Suggestions Big Twin Flatties Shift lever profile

Shift lever profile

Moderators: Curt!, Pa

Post Fri Mar 28, 2008 5:54 am

Posts: 22
Location: Connecticut Shoreline
I am ready to send my shift lever out to get chromed. The bottom where the rod attaches is not flat, it curls up a bit.
The top where the knob screws on looks like the outward angle was messed with as well.

Does anyone have their shift lever off and could they post an image of it lying on it's backside so I can compare it's profile to mine ?
1977 XLH (3A)
1977 FLHS (7E)
1971 SX125 (7A)
1934 VLD (Under Restoration)


Post Fri Mar 28, 2008 7:03 am

Posts: 634
Location: Wisconsin, USA
You are looking for a picture of the lever for a VL? Are you using the flatstock lever or the die stamped piece? I'll try to get a picture of each.

Post Wed Apr 02, 2008 7:00 am

Posts: 634
Location: Wisconsin, USA
Lugnut, I sent you a PM. I took a couple of pictures of the levers if you need them.

Return to Big Twin Flatties