Board index Flathead Power-Technical Questions, Answers, and Suggestions Big Twin Flatties Rear brake backing plate

Rear brake backing plate

Moderators: Curt!, Pa

Post Mon Nov 13, 2006 9:36 pm
Chuck Sumner

:?: I have a few rear brake backing plates with the anchor broke off. Does anyone make a replacement ? Is the anchor heat treated ? I have thought of making some. We have a nice fab shop to use so this isnt a home repair. Any info appricated

Post Mon Nov 13, 2006 11:45 pm

Posts: 630
Location: belgium
Iff you make some I'm interested in a few to.
I wonder why they get F***** so often....

Post Tue Nov 14, 2006 7:51 am

Posts: 634
Location: Wisconsin, USA
Axle sleeve nut isn't tightened enough. I think a lot of people didn' have a proper tool and snugged with a pliers or something. I would like to have some replacement stops too, if you have some made up Chuck.

Post Tue Nov 14, 2006 7:23 pm
Chuck Sumner

:!: Looks like we might be making some up then, thought I was the only one with broke anchors. When I find out about what type metal and if heat treating is necessary, I will get on it.

Return to Big Twin Flatties