Big Twin Flathead Frame.

Anyone out there know who manufactures a big twin rigid frame for my 40UL ? Mine was raked years ago,by cutting and bending the frame tubes in between the gas tanks.Been arround bikes for a while but never seen that done before.Have one supposedly on order from V Twin(TEDD) for the last nine weeks and still nothing,with no happy ending in sight.Need to get this project off the ground ! Would appreciate any info. Thanks JoeE

I have seen a number of frames raked that way over the years.

As far as the frame from Teds, unless things have changed that frame is made in Connecticut and if I remember right it is done by Corbin or one of Corbins other companies. There are probably other companies making one but the frame from Teds sure looked good. I have never used one so I am not sure about the fit up.

Jim

Try these guys

http://www.raceframe.com.au

harrison