Board index Flathead Power-Technical Questions, Answers, and Suggestions Big Twin Flatties UL cylinder

UL cylinder

Moderators: Curt!, Pa

Post Sat Jul 27, 2002 1:33 am

Posts: 180
Location: Boca Raton, FL., USA

I'm missing only one part to complete my '42U project----that is a good rear cylinder ( bare is OK)that is no more than .060 over bored. I only post this here because I've been unable to find one anywhere else. If anyone can help ( I have cash waiting) please e-mail me. I would buy a set of Anders , but I only need the rear one. Thanks.

Post Sat Jul 27, 2002 2:28 am

Posts: 376
Location: Lebanon, CT USA
mcgeezer1945@aol.com...I think I can help you

Post Sat Jul 27, 2002 10:58 pm

Posts: 180
Location: Boca Raton, FL., USA

Is it just me or is M/Cgeezer not getting back to anyone with his UL parts stash? I seem to recall a large quantity of UL cases , cylinders, heads , etc., that he said he had , but I am unable to get any response about these parts. Anyone?

Post Sun Jul 28, 2002 12:08 am

Posts: 376
Location: Lebanon, CT USA
my computer is not working and i have to use the one at my real job...i responded to your e-mail and several others...apparently they did not get out to where they were supposed to go...sorry about that...hopefully my computer gugu will get the bugs out soon and i can get back to business..mean time i am losing my lease and will be relocating my shop... try my e-mail again or call me
@860-423-6332 geezer


Return to Big Twin Flatties

cron