Board index Flathead Power-Technical Questions, Answers, and Suggestions Big Twin Flatties setting up magneto....need help

setting up magneto....need help

Post Sun Feb 10, 2013 4:07 pm
yp

Posts: 162
Location: athens,greece
Hello again.....
I am setting up the wiring on a ul project and have got the motor ready with morris magneto....
was wondering if anyone could help me out with how i wire this up,i have never ran one of these.....
I have a 6v 32e generator and new 6v electronic type relay.....
was planning on using these and battery for lights......but again have no experience with this.....
have tried to find a wiring diagram on the net but nothing came up.....
If anyone could help me out with what i have to do/use would be very much appreciated......
thanks in advance.....

Post Sun Feb 10, 2013 11:09 pm

Posts: 693
Location: somerset, oh usa
One plug wire to each spark plug, mix match to your liking......
WLA wiring diagram should provide the info needed on generator hookup.
Do a search here.

Post Wed Feb 13, 2013 6:36 pm

Posts: 497
Location: Six miles East of Cheney, Wa.
Should be no wiring involved with a magneto, except something to ground/kill the ignition when you want to shut the motor off. ??

Post Tue Feb 26, 2013 11:04 pm

Posts: 2688
Location: Los Angeles, CA
knucklebolt wrote:
Should be no wiring involved with a magneto, except something to ground/kill the ignition when you want to shut the motor off. ??


Yup....... :mrgreen:


Return to Big Twin Flatties

cron