Board index Flathead Power-Technical Questions, Answers, and Suggestions Big Twin Flatties S&S Reproduction Kick Cover

S&S Reproduction Kick Cover

Moderators: Curt!, Pa

Post Wed Oct 03, 2012 6:27 am

Posts: 636
Location: Wisconsin, USA
I just fitted a new kick cover to a 1940 transmission. The S&S Repro cover is a very nice piece, but if you use the early throwout bearing, you will need to do a little clearancing inside the cover near the fork so the bearing will have full travel. The area in question is at the junction of the cast- in bevel and the machined slot for the fork, just above the foundry marks.

Return to Big Twin Flatties