- Exhaust (select all)
- Air Cleaners (select all)
- Engine Kits (28)
- Engines (select all)
- Crankcase (28)
- Flywheels (32)
- Camshafts (120)
- Carburetors (82)
- Manifolds (47)
- Oil Pumps (33)
- Gear Covers (5)
- Cylinders & Pistons (0)
- Cylinders / Pistons (328)
- Cylinder Heads (48)
- Tappets (18)
- Pushrods (39)
- Rocker Arms (12)
- Valve Springs (20)
- Rocker Covers (8)
- Throttle Bodies (13)
- Electronics (31)
- Transmission (8)
- Clutch (8)
- Lubricants (12)
- Gaskets (45)
- 1999–’04 Twin Cam 88®/88B™ with stock heads (5/16" valve stems)
- 1984-’99 Evolution® with stock or S&S Super Stock® heads
- 1986-’03 Harley-Davidson® Sportster® Models
- 1994-’02 Buell® Models
- All S&S Super Stock® heads (5/16" valve stems)
FEATURES AND BENEFITS:
- Patented steel top collars are drilled for lightness and to increase cooling oil flow over valve springs
- For very high performance applications, kits with low mass titanium top collars are also available
- Valve keepers
- Top & Bottom collars
- Outer & Inner springs
- Use with shoulderless-style valve guides.
- Special keepers included fit valves with stock 5⁄16" stems and S&S collars only.
- Spring seat force is typically 170 lbs. at stock 1.800" installed height.
- Open force is 390 lbs. at .560" lift, 415 lbs. at .630" lift.
- May also be used in any other heads that require stock O.D. outer spring.
- S&S springs will not fit 2005 - later stock heads because of the change invalve spring and valve stem diameter.
|S&S® .640" Valve Springs Specifications – 1948-’84 Big Twin|
|Lift||Installed Height||Seat Force||Force at Max Lift|
|.640"||1.800""||170 lb.||419 lb.|
High lift cams may require the engine builder to obtain additional clearance between the piston and valves, the intake and exhaust valves and the upper spring collar and rocker cover. Clearance should also be checked between the rocker arm and valve spring collar as well as between the rocker arm and rocker cover. It is imperative that the engine builder confirm these clearances and check for spring coil bind, even when using parts specifically designed for high performance. Most valve train failures can be traced to over-revving or failure to confirm correct clearances during assembly.